Reason analysis and treatment methods for Festo cylinder not working

July 16, 2024

The lateral load of Festo cylinder during operation should not exceed its allowable value. During use, it can maintain the normal operation and service life of the cylinder. Prevent moisture freezing in the system.

When the operating speed of Festo cylinders is slower than normal, there are many factors that contribute to this willingness. The product needs to measure the pressure of its main system during use, and then check whether the pressure system is consistent with the initial setting.Pneumatic Cylinder Barrel.

If the Festo cylinder is removed and not used, it is necessary to pay attention to the rust proof surface of the product. The air inlet and exhaust ports of the equipment need to be equipped with dust covers. Due to the high precision of product production and guidance, please do not disassemble the cylinder for fixation by yourself. Cylinder block and Pneumatic Cylinder head.

The Festo cylinder belongs to pneumatic components, so the answer to this question is affirmative, there is no doubt about it. In addition, it should be noted that pneumatic components mainly include gas source processing components, pneumatic control components, pneumatic actuators, and pneumatic auxiliary components, and cylinders belong to pneumatic actuators.

The Festo cylinder system controls position, speed, and torque. The device needs to effectively complete its linear motion during use and can effectively convert transmission through mechanical devices such as toothed belts or screws, so the structure is relatively complex.

The structure and principle of Festo cylinders are very simple. The entire device is easy to install and maintain. The output force in the device is directly proportional to the square of the cylinder diameter, so the output force of the electric cylinder is directly related to the power of the motor, the cylinder diameter, and the pitch of the screw. It matters.

Festo cylinders have strong applicability, and the equipment can work normally in high and low temperature environments. The equipment has a certain waterproof ability during use, making it very suitable for use in various harsh environments. Analysis and treatment methods for the non operation of the Festo cylinder.

First, use the Festo cylinder and remove the ductile flat washer (screw) at the end of the cylinder with a caliper, then remove the cylinder piston rod. This is because the sealing ring is too damaged, so remove the sealing ring, install a new sealing kit, and clean the cylinder block to ensure that both intake ports are unobstructed. Everything is normal, use a small amount of crystallized salt free butter to scrub the inside of the drum. Install an extensible flat washer at the end of the cylinder to extend its lifespan by 1 to 2 years.

The crawling of the Festo cylinder is generally a phenomenon that occurs when the cylinder pressure is restored and its thrust exceeds the fine friction force. The main reason is that the dynamic friction and static friction resistance of the cylinder are different during movement, which leads to this problem. On the cylinder, a boost valve can be used, but it still depends on the specific situation, such as whether the cylinder can withstand it, whether it is easy to operate and use, and whether it will bring some benefits. If one of them has a problem, the booster valve cannot be used. Special cylinders are developed on the basis of ordinary cylinders. Specifically, it is a modification of the structure of ordinary cylinders to meet different work requirements, while obtaining some special performance or functionality to reflect their uniqueness.

Author:

Mr. WEIYINGSI

E-mail:

info@wyspneumatic.com

Phone/WhatsApp:

18038711802